Hitachi Compute Blade 2500 - 3 Starting the CB 2500 and Performing Initial Setup

3
Starting the CB 2500 and Performing
Initial Setup
This chapter describes the initial setup that is required from installation of the
system unit to powering on the server blades.
□
Connecting the system unit to the power supply
□
Preparing the system console used for configuring the settings of the CB
2500
□
Setting the network for the server blades and modules
□
Preparing the server blades so that they can operate in LP mode
□
Powering on the server blade
□
Resetting the power of the server blade
□
Restarting the BMC of a server blade
□
Setting the UEFI of a server blade
Starting the CB 2500 and Performing Initial Setup
3-1
Hitachi Compute Blade 2500 Series Getting Started Guide