Hitachi Compute Blade 2500 - Appearance of the management LAN module

This LED lights up when an error occurs on a server blade or module in
the system unit. On the standby management module, this LED is always
off.
9. MM SHDN switch
Use this switch to power off the management module. To power off the
management module, press and hold this switch for at least four seconds.
10. MM PWR LED
The lights of this LED signify the following statuses:
¢
Green light ON: The management module is powered on.
¢
Flashing green: The management module is being started or shut
down.
¢
OFF: The management module is powered off.
11. MM HB LED
This LED flashes green when the management module is running.
Appearance of the management LAN module
The management LAN module has connectors for connecting with the
management LAN and indicators to show the status of the management LAN
module itself. The management LAN module and the management module
are connected via the backplane.
The appearance of the management LAN module is shown below.
Figure 2-23 Management LAN module
The connectors and indicators on the management LAN module are described
below.
Figure 2-24 Management LAN module connectors and indicators
1
.
MGMT1 port, MGMT2 port
#
2-20
CB 2500 Appearance
Hitachi Compute Blade 2500 Series Getting Started Guide