Hitachi Compute Blade 2500 - Page 149

K
KVM 2-7, 2-11
L
LAN switch module
setting user account 3-8
LCD touch console 1-9, 1-13
LID LED 2-8, 2-12, 2-17, 2-21
LNK SMP LED 2-8
location tag 2-5
logging in 3-5
LP LED 2-9
LP mode 3-11
powering off 4-2
LPAR 1-6
LPAR manager
host idle loop 1-7
LPAR 1-6
LPAR manager functionality 1-6
M
MAINT port 2-21
MakeCDImg.exe 5-14
management LAN 1-7
Management LAN module
indicators 2-20
management LAN module
appearance 2-20
connectors 2-20
LID LED 2-21
MAINT port 2-21
MGMT port 2-20
PWR/WRN LED 2-21
management module 1-2, 1-5
active management module 1-5
appearance 2-18
changing network address 3-7
changing the password 3-6
connecting by using LAN cable 3-3
connecting by using RS232C cable 3-4
connectors 2-19
indicators 2-19
logging in 3-5
MM ALM LED 2-19
MM HB LED 2-20
MM MSR LED 2-19
MM PWR LED 2-20
MM SHDN switch 2-20
serial port 2-19
standby management module 1-5
switches 2-19
system ALM LED 2-19
system LID LED 2-19
system PWR LED 2-19
system WRN LED 2-19
USB port 2-19
MEM LED 2-9
memory dump 5-2
memory scrubbing 1-4
MGMT port 2-20
MIS LED 2-9
MM ALM LED 2-19
MM HB LED 2-20
MM MSR LED 2-19
MM PWR LED 2-20
MM SHDN switch 2-20
module
fan module 1-2, 1-6
I/O board module 1-2, 1-6
management module 1-2, 1-5
power supply module 1-2, 1-6
switch module 1-2, 1-6
N
N+M cold standby 1-7
navigation area 1-12
NMI LED 2-9
NMI reset switch 2-7, 2-11
normal rated power supply 3-2
Notes 5-12
notes 5-2
O
onboard CNA 1-4
OUT LED 2-25
P
PCI expansion blade 1-2, 2-12
appearance 2-13
PCI Express adapter 1-6
Index-3
Hitachi Compute Blade 2500 Series Getting Started Guide