Hitachi VM-E110E - Maintenance.36; Specifications

MAINTENANCE
1. To maintain the optimum performance of this
camera/recorder, regular periodic mainten¬
ance is required. Your dealer will advise you
further.
2. Maintenance and adjustments may not be car¬
ried out by the user. In all cases of difficulty or
doubt, consult your dealer.
3. H ead cleaning
Dirt accumulated on the video heads after a
period of time may cause the playback picture
to become blurred or part of the video infor¬
mation to be lost. This does not mean that the
recorded programme has been erased but
head cleaning is required.
Use a dry type head cleaning tape to clean the
video heads.
When it is difficult to remove a dirt using the
head cleaning tape, head cleaning requiring
highly technical care is necessary.
Consult your nearest dealer or VCR service
centre for head cleaning.
SPECIFICATIONS
■ General
Power requirements
Power consumption
Operating temperature
Operating humidity
Storage temperature
Dimensions
Weight
■ Video Recorder Section
Format
Record/playback system
Video signal
Tape speed
Video output
Audio output
Fast forward/rewind time
6V DC
4.8 watts (when recording)
OX to 40°C
< 80%
- 20°C to 60°C
94{W)x 120(H) X 211(D) mm
Approx. 865g (without battery pack, lens hood, lens
cap and cassette)
8mm
Two video record/playback heads
PAL colour & CCIR monochrome signals 625 lines
SP: 20.05 mm/sec.
1.0 Vp-p, 75 ohm
- 8 dBs, less than IK ohm
Less than 8 minutes with P5-90 cassette
■ Camera Section
Scanning
Required minimum illumination
Camera device
Lens diameter
625 lines/50 fields/25 frames
2 lux
1/4" C.C.D
46 mm
36