58
Flight Conditions cont.
If more than one ight condition is concurrently enabled, the condition with the highest
number (per the table shown above) will be active. The eld just below the model icon on the
Home screen indicates the active ight condition.
5. Scroll to highlight the “SPEED” eld and press the jog dial to
activate the menu.
6. Scroll to dene the amount of time (0.0 to 10.0 seconds) to
transition the settings when this ight condition is enabled.
Press the jog dial to conrm your selection. This feature can
be utilized to prevent sudden control surface movements
when switching between ight conditions.
- Press the back button twice to return to the ight conditions menu.
7. Press the back button to return to the ight conditions menu and repeat steps 2-6 to dene further
ight conditions.
8. Press the back button twice to return to the model function menu.
Aileron Differentials
The Aileron Dierential function allows you to program greater upward aileron movement than
downward movement on models with more than one wing servo. This setup is commonly used to correct
airplanes that tend to yaw in the opposite direction of a roll (adverse yaw). You may also wish to congure
aileron-rudder mixing in this situation.
1. From the model menu, rotate the jog dial to highlight “AIL
DIFF” and press the jog dial once to enter the aileron
dierential menu.
2. Scroll to the “RATE” eld and press the jog dial to activate the
menu.
3. Scroll to input the desired rate value. This value represents the
dierence between 100% downward travel and the adjusted
travel. A rate value of 50 is typically a good starting point. Note
that the travel values displayed in the “AILE” and AIL2” elds
reect changes to the rate value.
You can also enter the timer menu directly from the home screen. Scroll to highlight a timer on
the screen and press the jog dial.
To Next Page
Loading...
Need help?
General
