62
Ailevator Mixing
The Ailevator feature allows the conguration of a two-servo or “split” elevator setup. It also features an
“aileron to split elevator” mix which allows the elevators to provide roll control. This feature, also called
“tailerons”, is commonly used on jet models.
1. From the model menu, rotate the jog dial to highlight
“AILEVATOR” and press the jog dial once to enter the ailevator
mix menu.
9. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “RUDD” receiver slot. This value regards the
servo travel when a left roll command is given. Press the jog
dial to conrm your input.
8. Scroll to the top “ELE2” eld and press the jog dial to activate
the menu.
2. Scroll to the top “ELEV” eld and press the jog dial to activate
the menu.
3. Scroll to highlight the “L/U” (left/up) eld and press the jog dial
to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “ELEV” receiver slot. This value regards the
servo travel when a left roll command is given. Press the jog
dial to conrm your input.
5. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a right
roll command is given. Press the jog dial to conrm your input.
7. Press the back button to return to the ailevator menu.
To Next Page
Loading...
Need help?
General
