61
V-Tail Mixing cont.
5. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to conrm your
input.
3. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “ELEV” receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
9. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “RUDD” receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
7. Press the back button to return to the V-tail menu.
8. Scroll to the top “RUDD” eld and press the jog dial to activate
the menu.
11. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a
pitch down command is given. Press the jog dial to conrm
your input.
13. Press the back button the return to the V-tail Mix menu.
14. Repeat steps 2-13 using the lower “ELEV” and “RUDD” elds to set servo endpoints when yaw (rudder)
commands are given.
15. If elevator and/or rudder functions operate in the incorrect
direction, highlight the direction eld (“nor”) under the
reversed function and press the jog dial to activate the menu.
16. Scroll to select “rev” and press the jog dial to conrm your
selection. Verify that the control surfaces now move in the
correct direction.
17. Push the back button twice to return to the model function menu.
To Next Page
Loading...
