40
Control Modes
1. To enter the Management menu scroll to MANAGEMENT from
the System Menu and press the jog dial to enter the menu.
2. Scroll to highlight “BACKLIGHT” and press the jog dial to
activate the menu.
3. Scroll to select the amount of time that the screen backlight
will stay active without manipulating the jog dial or back
button. Press the jog dial to conrm your selection.
Management Menu
The Management menu allows you to tailor numerous system-wide features of the Flash 7.
From the management menu, you can control the following:
User Interface screen backlight duration and contrast.
Battery type used in the transmitter.
UI Feedback - Audible tones during warnings and when you press or scroll the jog dial.
Warning Setup – Audible warnings when the transmitter is powered on.
3. Scroll through the modes until you nd the one you would
like to use. The selected mode will be applied to each
new model that is created. Press the jog dial to conrm your
selection.
Some modes require additional adjustments to the hardware of the Flash 7 transmitter. For more
information on the Flash 7’s hardware adjustments refer to Appendix A. Hardware adjustments.
The Flash 7 is capable of operating in control Modes 1 ~ 4. The default is mode 2 for models sold in North
America as this is generally preferred by the majority of pilots.
1. From the system menu, scroll to highlight “MODE” and press
the jog dial to enter the mode selection menu.
2. Press the jog dial again to activate the mode selections.
To Next Page
Loading...
Need help?
General
