HITEC Flash 7 - Acro and Glider Programming; Fixed-Wing Specific Functions

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
56
Acro and Glider Programming Menu
When the active model is congured as a xed-wing (ACRO or GLID) model type, the Model Function
menu contains programming options which are useful for xed-wing aircraft. This section describes the
features and programming steps for the ACRO and GLID model function menus.
From the Model Function menu, you can program the following xed-wing-specic functions:
*FLT.COND: Congure specic control settings for dierent phases of ight.
AIL DIFF: Congure aileron servos to move further upwards than down.
ELEVON MIX: Specify independent pitch and roll control throws for aircraft with elevons.
V-TAIL MIX: Specify independent pitch and yaw control throws for aircraft with a V-tail.
AILEVATOR: Specify independent pitch and roll control throws for aircraft with ailevators (also called
“tailerons”).
AIL>RUD: User-adjustable mix that denes rudder movement with aileron control inputs.
ELEV>CAMB: Alter wing control surfaces with elevator inputs.
Camber Mix (GLID only): Adjust wing control surfaces with switch movements.
*FLAP CON: Mix elevator throw with ap movement.
OFFSET: Fine tune aileron, elevator, and ap positions.
B-y (GLID only): Congure wing control surfaces to act as an air brake (also known as “crow”).
GYRO: Specify gyro on/o and sensitivity settings.
THRO CUT (ACRO only): Congure a kill switch for glow/gas motors.
T.CURVE (ACRO only): Specify non-linear throttle response.
If you have not already programmed a model with the preceding quick start guide, we
encourage you to do so before tackling the model programming section of the manual.
Note
TipTip
Tip
Caution
ACRO Model Function Menu Page 1 ACRO Model Function Menu Page 2
Glider Model Function Menu Page 1 Glider Model Function Menu Page 2