HITEC Flash 7 User Manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
82
Flight Conditions cont.
Throttle Cut
Throttle Cut is a vital safety feature when ying glow or gas-powered models. This feature will command
the throttle servo to a preprogrammed position with a switch movement. You may choose to set the
servo to bring the engine to low-idle, or even shut it down.
To congure throttle cut:
If more than one ight condition is concurrently enabled, the condition with the highest
number (per the table shown above) will be active. The eld just below the model icon on the
Home screen indicates the active ight condition.
Note
TipTip
Tip
5. Scroll to highlight the “SPEED” eld and press the jog dial to
activate the menu.
6. Scroll to dene the amount of time (0.0 to 10.0 seconds) to
transition the settings when this ight condition is enabled.
Press the jog dial to conrm your selection. This feature can
be utilized to prevent sudden control surface movements
when switching between ight conditions.
7. Press the back button to return to the ight conditions menu
and repeat steps 2-6 to dene further ight conditions.
8. Press the back button twice to return to the model function
menu.
1. From the model menu, rotate the jog dial to highlight “THRO
CUT” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to conrm your selection and activate the throttle cut
menu.

HITEC Flash 7 Specifications

General

Brand	HITEC
Model	Flash 7
Category	Remote Control
Language	English