HITEC Flash 7 User Manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
88
Revolution Mixing cont.
c. If you choose “Cond” (Flight Condition):
- The upper right eld of the menu displays which ight
condition is currently active and will be programmed.
- Scroll to the Flight Condition eld and press the jog dial to
activate the menu.
- Choose the desired ight condition and press the jog dial to
conrm your selection.
You may also select a ight condition in this menu by activating the desired ight condition.
Note
TipTip
Tip
Caution
13. Repeat step 12b as applicable to dene the REVO Mix for every ight condition.
14. Press the Back button to return to the Model Function menu.
To disable the revolution mix:
1. Scroll to highlight the “MIX” eld in the Revolution Mix menu
and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to conrm your
selection.
3. Press the Back button to return to the Model Function menu.
Swash to Throttle Mixing
A swash to throttle mix is typically used to increase main rotor RPM when a swash control command is
input to the helicopter. The increased RPM compensates for the loss of lift due to tilting the rotor.
1. From the Model menu, rotate the jog dial to highlight
“SWASH>THRO” and press the jog dial once to enter the
activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to conrm your selection and activate the swash-throttle
menu.

HITEC Flash 7 Specifications

General

Brand	HITEC
Model	Flash 7
Category	Remote Control
Language	English