7 Channel 2.4 GHz Aircraft Computer Radio System
Section 7: Using the Telemtry System
97
GPS cont.
1. From the sensor menu, rotate the jog dial to highlight “GPS”
and press the jog dial once to enter the GPS menu.
selection.
3. Scroll to select “Metric” (meters, meters per second) or
“Imperial” (feet, feet per second) units and press the jog dial to
selection.
5. Scroll to select “RELATIVE” or “ABSOLUTE”. Relative mode is the most commonly used option. . In this
setting, altitude is displayed as the model’s height above the launch altitude. If absolute is selected, the
altitude will be displayed as the model’s height above sea level.
6. Press the back button to return to the sensor menu.
RPM
The RPM screen displays rpm data for electric, glow, or gas motors in an airplane or helicopter. Data from
two sensors can be displayed simultaneously.
Required Sensor: HTS-MRPM Magnetic RPM Sensor or HTS-ORPM Optical RPM Sensor.
1. From the sensor menu, rotate the jog dial to highlight “RPM”
and press the jog dial once to enter the RPM menu.
your selection.
To Next Page
Loading...
Need help?
General
