HITEC Flash 7 User Manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
84
Throttle Hold cont.
1. From the Model menu, rotate the jog dial to highlight T.HOLD
and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to conrm your selection and activate the T.Hold menu.
4. Scroll to the “RATE” eld and press the jog button to activate
the menu.
5. Use the jog dial to place a rate value for the hold position you
want the throttle to be at when the hold switch is activated.
To disable the T.HOLD function:
1. Scroll to highlight the “MIX” eld in the T.HOLD menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to conrm your
selection.
3. Press the Back button to return to the Model Function menu.
Gyro
It is often desirable to use a gyro to help stabilize the tail rotor on helicopters. The Flash 7 provides up to
three gyro sensitivity settings per model memory. The gyro setting can also be specied for each dened
ight condition.
The GYRO function must be assigned to a channel before this option will appear in the Model
function menu. See Section 3 for instructions regarding the Channel menu.
Note
TipTip
Tip
Caution
1. From the Model menu, rotate the jog dial to highlight “GYRO”
and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.

HITEC Flash 7 Specifications

General

Brand	HITEC
Model	Flash 7
Category	Remote Control
Language	English