28
System Menu
From the System Menu you can do the following:
MDL.SEL: Model Select Menu.
SELECT: Select an existing model.
NEW: Create a new model.
COPY: Copy one model’s data into a new model memory slot.
RESET: Reset the model memory to the factory defaults.
DELETE: Delete a model memory.
RENAME: Rename the model to a name of your choice.
MDL TYPE: Model Type Menu.
ACRO: Provides programming for most powered xed wing aircraft.
GLID: Provides programming for Gliders both powered and unpowered.
HELI: Provides Helicopter programming functions.
CHANNEL: Model channel assignment Menu. Allows control of any channel to be assigned to a switch or
joystick axis.
TRIM STEP: Trim step size adjustment menu (1-200). Default is 12.
TRAINER: Trainer options menu.
SENSOR: Telemetry sensor setup menu.
SPECTRA: Receiver set-up.
Range Check Mode: Power down mode for performing preight range check.
Binding: Use to bind a new receiver to your Flash 7.
Scanning: Scan the frequency table for the clearest channels.
MODE: Stick mode change Mode 1-4.
MANAGEMENT: System Management Menu.
BACKLIGHT: Adjusts how long the backlight stays on.
CONTRAST: Adjusts the screen contrast.
BATTERY: Used to specify the battery type used in the transmitter: Alkaline, NiMh/NiCD, LiPo or
LiFe.
If you have not already programmed a model with the preceding quick start guide, we
encourage you to do so before tackling the System and Model programming sections of the manual.
There are two primary menus in the Flash 7 programming structure. The System function Menu and the
Model function Menu. The rst menu we will explore is the System Menu. This menu has all the common
programming function that are available for ACRO, GLID and HELI models. There are also numerous
options for customizing the operating characteristics of the Flash 7 transmitter.
To Next Page
Loading...
Need help?
General
