HITEC Flash 7 User Manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 1: Introduction
21
Range Check Function
It is critical that before each ight session you perform a range check that conrms the signal between
the receiver and transmitter is appropriate. To do a range check, use a power-down mode to reduce the
transmitter signal strength. During this power-down mode, you should walk away from the secured
aircraft carrying the transmitter to a distance of approx. 30 meters, to test the eective range.
2. Press the jog dial and back button simultaneously to enter the
System Menu list. From here, scroll to the SPECTRA function
and press the jog dial to enter the Spectra setup menu.
3. Scroll to the RANGE CHECK and push the jog dial to enter the
range check function.
4. If you are sure you want to proceed with the range check,
select “Yes” and press the jog dial to continue.
5. Walk away from the secured aircraft carrying the transmitter
to a distance of approx. 30 meters, to test the eective range.
Once you have completed the range check, push the jog dial
to end the range check.
1. Turn on the transmitter and select “Yes” from the “Ready to
Transmit” prompt by pressing the jog dial.

HITEC Flash 7 Specifications

General

Brand	HITEC
Model	Flash 7
Category	Remote Control
Language	English