Version 1.1, 02/2014. Copyright 2012 Hitron Technologies
66
Version 1.1, 02/2014. Copyright 2014 Hitron Technologies
66
Hitron CGNV4 User’s Guide
The following table describes the labels in this screen.
Table 21: The Wireless: Basic Settings 2.4GHz Screen
Basic Settings
Wireless Enabled Use this field to turn the 2.4GHz wireless network on or
off.
Select ON to enable the wireless network.
Select OFF to disable the wireless network.
Wireless Mode Select the type of 2.4GHz wireless network that you
want to use:
802.11 11b Only: use IEEE 802.11b
802.11 11g Only: use IEEE 802.11g
802.11 11n Only: use IEEE 802.11n
802.11 B/G/N Mixed: use IEEE 802.11b, 802.11g
and 802.11n
802.11 G/N Mixed: use IEEE 802.11g and 802.11n
NOTE: Only wireless clients that support the network
protocol you select can connect to the wireless
network. If in doubt, use 11B/G/N Mixed
(default).
Channel Bandwidth This field allows you to configure the width of the radio
channel the CGNV4 uses to communicate with its
wireless clients (IEEE 802.11n only). Using the full
40MHz bandwidth can double your data speed.
Select 20 MHz to only use a 20 megahertz band.
Select 20/40 MHz to use a 40 megahertz band
when possible, and a 20 megahertz band when a
40Mhz band is unavailable.
Select 40 MHz to only use a 40 megahertz band.
Wireless Channel Select the 2.4GHz wireless channel that you want to
use, or select Auto to have the CGNV4 select the
optimum channel to use.
NOTE: Use the Auto setting unless you have a specific
reason to do otherwise.
To Next Page
Loading...
Need help?
General
