RF-RKP - continued
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
40
• The RF-RKP’s programmable options can be accessed as follows;
• To get to the RF Keypad Opts (options) menu; select the Devices Menu. Then RF Devs Menu. Next select
the RF Devs Options. Scroll to RF RKP Opts.
2 Wired Devices Menu
1 RF Devices Menu
• When you select the RF Keypad Opts menu, you will see RK1 RF Keypad. Select this.
• RK Contrast, allows you to adjust the
keypad’s LCD contrast.
• RK BackLight, allows you to adjust the
keypad’s blue LCD light.
• RK Audio Vol, allows you to adjust the
keypad’s spoken messages.
• RK Buzz. Vol, allows you to adjust the
keypad’s buzzer volume.
• RK LEDs, when set to NO deactivates the
keypad’s status LEDs
• RK Tamper, when set to NO deactivates the
keypad’s tamper switch.
• RK Entry/Exit, allows activate or deactivate
the keypad’s Entry/Exit buzzer.
• Finally, RK Mon Sup (Monitored Supervisory signal) is defaulted to
YES. When the device is ‘lost’ for >120 minutes a supervisory alarm is
flagged by the panel. This can be turned off by selecting NO. However,
we recommend that this feature is left as YES.
Note: In RF System Options you can globally adjust the supervisory time by going to the Sup. Time
(supervisory Time) menu.
4 RF SABB Opts
4 RF SABB Opts
4 RK1 Buzz. Vol
1 RK1 Contrast
5 RF Wand Opts
5 RF Wand Opts
1 RK1 RF Keypad
5 RK1 LEDs
7 RK1 Entry/Exit
2 RK1 BackLight
6 RF RKP Opts
6 RF Keypad Opts
6 RK1 Tamper
8 RK1 Mon Sup
3 RK1 Audio Vol
!
!
Note: Recording the site name via the RF-RKP’s microphone is not available
!
Note: If there are no wired or RF keypads already assigned to the system and you then power-up an
RF-RKP within range, it will automatically attach itself to the system. It will detach itself if it is out of range for 10
minutes or there are no key-presses for 1 hour. To stop it from detaching, it will need to be Added & ID’ed.
If there has already been a wired or RF keypad assigned to the system you can still get an RF-RKP to
automatically attach so long as you are in Engineer mode and the tamper switch is open. Again, to stop it from
detaching, it will need to be Added & ID’ed.
To Next Page
Loading...
Need help?
General
