User manual C4 – C6
78
Affix the other end of the ballast removal support with the locking
pin (see figure 96). Make sure the cable is not twisted and does not
have any loops/windings.
Figure: 96
Switch on the control and slide the boom out until tension is just
applied to the ballast cable. Make sure the ballast cable is routed
correctly over the cable sheave (see figure 97). Also be careful that
the front of the boom does not contact anything (see figure 98).
Figure: 97
Figure: 98
Use a 24 mm spanner to remove the two hex bolts that hold the
ballast retainer in place (see figure 99). Remove the silver coloured
plate that was held by the bolts.
Figure: 99
Slide the boom out slightly until the ballast is completely supported
by the cable (see figure 100).
Figure: 100
Slide the ballast frame completely in; the ballast is now hanging
free (see figure 101).
Figure: 101
To Next Page
Loading...