Honda BF75A - 11 Cleaning and Flushing

−
106
CLEANING AND FLUSHING
FLUSH PLUG
FLUSH PLUG
HOLE CAP
HOSE JOINT
(optional)
WATER HOSE
11.
Wash the outside of the outboard
motor with clean, fresh water.
Pull the flush plug hole cap off the
motor.
Install the water hose joint
(optional part).
Connect a fresh water hose to the
water hose joint.
After flushing, remove the water
hose and water hose joint and
reinstall the flush plug hole cap.
Thoroughly clean and flush the
outboard motor with fresh water after
operating in dirty or salty water. Turn on the fresh water supply to
the hose and flush the motor for 5
6 minutes.1.
2.
3. 4.
5.
6.
05/10/26 10:01:05 3CZW0612_106