×
×
53
Other Checks
The possibility of corrosion
damage is increased if the anode
metal is painted over or allowed to
deteriorate.
Check the following items:
PRE-OPERATION CHECKS
(2)
(1)
(2)
(3)
(3)
(4)
(6)
(5) TOOL KIT
10 12 mm WRENCH
8 mm WRENCH
FLAT SCREWDRIVER
STARTER ROPE
PLIERS
TOOL BAG
14 17 mm WRENCH
PHILIPS
SCREWDRIVER
SCREWDRIVER
HANDLE
OWNER’S MANUAL
SPARK PLUG WRENCH
OIL CHECK SCREWDRIVER
Owner’s Manual
Tool kit
Spare parts: spark plugs, engine oil,
spare propeller, plain washer,
castle nut, and cotter pin.
Other parts/materials required by
laws/regulations.
The anode metal (sacrificed metal)
helps to protect the outboard motor
from corrosion damage; it must be
exposed directly to the water
whenever the motor is in use.
Replace the anode metal when it has
been reduced to approximately one
half of its original size.
The fuel hose for kinking,
collapsing or a loose connection.
The tiller handle for loose, play or
smooth operation.
The control lever for smooth
operation.
The switch for correct operation.
The stern bracket for damage.
The tool kit for missing spare parts
and tools.
The anode metal for damage,
looseness or excessive corrosion.
Parts/materials which should be
installed on board:
(1)
(2)
(3)
(4)
(5)
(6)
(2)
(1)
(3)
(4)
05/10/26 09:52:45 3CZW0612_053
To Next Page
Loading...
