Honeywell CIPer 50 - USB 2.0 Device Interface; Ethernet; RJ45 Sockets

CIPer
TM
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
31-00233-02
14
USB 2.0 Device Interface
All models of the CIPer Model 50 controller are equipped with a USB 2.0 Device Interface at the front. This
interface is for connection to WEBs N4 and web browsers, or 3
rd
-party touch panels.
Figure 7: USB 2.0 Device Interface
A standard USB type-B connector can be inserted into this USB 2.0 Device Interface. This USB 2.0 Device
Interface is the recommended interface for connection to WEBs N4.
Ethernet / RJ45 Sockets
The CIPer Model 50 controller is equipped with two Ethernet / RJ45 sockets, each featuring two LEDs.
Figure 8: Ethernet / RJ45 sockets
The two Ethernet / RJ45 sockets are 10/100-Mbit/s Ethernet interfaces permitting communication (as per
IEEEC 802.3) on any supported IP network, e.g.: BACnet (IP), FOX, etc.
END BIAS MID
ETHERNET / RJ45 SOCKETS
INTER-
FACE 2
INTER-
FACE 1