CIPer
TM
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
22 … 248 °F (-30…..+120°C)
NOTE
In the case of temperatures lying outside the aforementioned ranges, the lowest/highest value
within the range, instead, will be communicated. Thus, a temperature of -59.8°F (-51 °C) will be
communicated as " -58°F (-50 °C)."
Sensor Characteristics
The characteristics (resistance in relation to temperature) of the sensors and the resultant voltage are listed
on the following pages. The stated values do not include failures due to: sensor failures; wiring resistance or
wiring failures; misreading due to a meter connected to measure resistance or voltage at the input.
NTC 20 kΩ (Type II) Temperature Characteristics
NTC 20 kΩ (same voltages for inputs of Panel Bus I/O Modules and Onboard inputs of CIPer Model 50).
NTC 20 kΩ (Type II) Temperature
NTC 20 kΩ (Type II) Temperature