Honeywell CIPer 50 - L1 Led; L2 Led

CIPer
TM
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
31-00233-02
68
L1 LED
Table 30. CIPer Model 50 controller bus L1 LED
Case
Bus LED
Meaning
Remedy
1
ON continuously after
power-up
Normal operation; Daemon
starting.
No action necessary.
2
Flashes constantly
Station starting; if L2 is also
flashing, then the station
has started.
No action necessary.
3
OFF
Severe software problems.
Contact TAC.
L2 LED
Table 31. CIPer Model 50 controller bus L2 LED
Case
Bus LED
Meaning
Remedy
1
ON continuously after
power-up
Platform has started / is
reachable.
No action necessary.
2
OFF
Station is not running.
• Start station (enable auto start).
• Contact TAC.
3
Flashing
Station has started.
No action necessary.