CIPer
TM
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
IMPORTANT
To allow the evaporation of any condensation resulting from low shipping / storage temperatures,
keep the controller at room temperature for at least 24hrs before applying power.
US requirement, only: This device must be installed in a UL-listed enclosure offering adequate
space to maintain the segregation of line voltage field wiring and Class 2 field wiring.
In the case of vertical mounting on DIN rails, the CIPer Model 50 controller should be secured in
place using a commercially available stopper. See also the CIPer Model 50 Mounting Instructions-
31-00234.
Dimensions
Figure 21: CIPer Model 50 controller (w/o HMI but with RJ45 socket for connection of portable HMI, and
with full complement of onboard I/Os), dimensions in inches (mm)
Figure 22: CIPer Model 50 controller with covers, dimensions in inches (mm)
NOTE
Use of the covers (MVC-80-AC1) obstructs access to the Ethernet and USB 2.0 Host Interfaces and
RS232 socket
4.33”
(
110)
2.4”(57.5)
1.94”(49.5)
8.4”(215.5)
2.05”(52)
1.8”
(45)
24V-0
24V~
1 2
DO1
DO2
DO3
IN
IN4
DO4
DO5
IN5
IN6
DO6
DO7
IN7
IN8
DO8
GND
AO1
AO2
AO3
5 6 7 8 9 10
11 12
13
14
15 16
17
18 19 20
21 22
AO4
23
24 25 26 27 28 29 30 31 32
GND1
485-1+
485-1-
n.a.
n.a.
GND2
485-2+
485-2-
n.a.
RS232
RS485-1
END
BIAS
MID
BI1
BI2
BI3
BI4
GND
UI1
UI2
UI3
UI4
UI5
UI6
UI7
33 34 35 36 37 38 39 40 41 42 43 44 45 46
UI8
47
UI9
UI10
2 1
2.4”
(57.5)
2.05”
(52)
8.4”
(215.5)
J1 J8
To Next Page
Loading...
