Honeywell CIPer 50 - Onboard I;O Modules

CIPer
TM
MODEL 50 CONTROLLER – INSTALLATION AND COMMISSIONING INSTRUCTIONS
31-00233-02
16
Figure 10: Allowed Ethernet wiring topology (“Switch functionality”)
NOTE
During any power failure of the CIPer Model 50, the switching functionality is inoperative.
Figure 11: Entering gateway address, disabling one of the two Ethernet interfaces in WEBs N4
WEB-EHSERIES
NX #1
max. 100 m
WEB-EHSERIESNX #2 WEB-EHSERIESNX #3
TO ACTIVATED
ETHERNET SOCKET
OF DEVICE #4
TO DEACTIVATED
ETHERNET SOCKET
OF DEVICE #1
max. 100 m
max. 100 m max. 100 m
SWITCH FUNCTIONALITY
max. 100 m max. 100 mmax. 100 m
CAT5
CABLE
WEB-EHSERIES
NX #2
WEB-EHSERIES
NX #4
WEB-EHSERIES
NX #3
WEB-EHSERIES
NX #5
ETHERNET/RJ45 SOCKET #2
DEACTIVATED
ETHERNET/RJ45 SOCKET #2
DEACTIVATED