Honeywell ECS Series User Manual

Model IFP-2100/ECS Installation Manual LS10143-001SK-E
9-29
9.6.6.2 Daylight Saving Time Start and End
This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the Automatic Daylight Savings Adjustment option under Daylight Savings
Options. The default values for the DST Start and End are:
DST Start: The second Sunday in March
DST End: The first Sunday in November
To set the start and end for Daylight Saving Time:
6. Press the up or down arrow key to select the week (1st, 2nd, etc.) Daylight Saving Time starts, then press
ENTER
to make your selection and move to the month setting.
7. Press the up or down arrow key to select the month (January – December) Daylight Saving Time starts, then
press ENTER
to make your selection and move to the DST End option.
8. Press the up or down arrow key to select the week (1st, 2nd, etc.) Daylight Saving Time ends, then press
ENTER to make your selection and move to the month setting.
9. Press the up or down arrow key to select the month (January – December) Daylight Saving Time ends, then
press ENTER
.
9.6.7 Edit Banner
The banner is the message that displays on the panel LCD when the system is normal; that is, when no alarms or
troubles exist and the system menus are not in use. A custom banner of up to 40 characters can be created. This
will automatically be centered when shown.
If a custom message is not created, the system will use the internal banner. You cannot change the internal
banner.
To customize the banner display message:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 5 for System Options.
4. Select 7 for Edit Banner.
Note: See Appendix B for instructions on how to edit the banner.
5. Select each letter by pressing the up or down arrow key to change modes and using the number keys to select
characters, then press right arrow key to move to the next character.
6. When done, press ENTER to save the custom banner.
9.6.8 SLC Family
The IFP-2100/ECS supports SD series, SK Series or IDP (Intelligent Device Protocol) series SLC devices. You
must configure the IFP-2100/ECS to accept the family of the devices you are installing.
Note: You cannot mix SD, SK and IDP series SLC devices on the same system.
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Press 8 to edit SLC Family.
5. Press UP arrow to select the desired SLC family.

Honeywell ECS Series Specifications

General

Brand	Honeywell
Model	ECS Series
Category	Conference System
Language	English