73022344 o
If, in addition, (integration) parameters have to be adjusted, the information required
for this purpose can be found in the software section and in the service manual.
CAUTION
Do not carry out any of the work described in this section if you do not have
permission and have not received the required training from the manufacturer
or its agents. (Honeywell can provide the required device-specific service and
commissioning training)
If the device is used for fiscal measurements, the presence of a calibration officer or its
representative is required for the final commissioning of the device. In this case, the
conditions set out in the relevant approval must also be satisfied.
For official (fiscal) operation, make sure that you also comply with the current
regulations relating to sealing and closing off the housing.
Finally, this section contains information which you should take into account if you no
longer wish to use the device or if you wish to use it at a different location.
To Next Page
Loading...
