73022344 o
Use suitable fastenings and mating parts in each fastening hole (i.e. nuts and bolts or
anchorings which fill the holes as much as possible). Select them on the basis of the
material and the type of installation surface. Ensure that your fastenings will withstand
a combined vertical load of at least 1000 N.
ATTENTION
Ensure that the device is installed in the correct position:
The device must always be operated in a horizontal position, with the analytical
modules and hood at the top.
The technical specifications and flawless operation will only be
guaranteed if the device is installed in the correct position.
Figure 6.6: Installation options 2
6.3.3 Assembly hints
The generally accepted rules of engineering for handling gases and/or electronic
components must be followed when carrying out the replacement work described below.
Many components are assembled with screws. Ensure that these screws are securely
tightened.
ATTENTION
When fitting the replacement parts, ensure that they are in the correct
position (left/right/top/bottom). The following figures show these
positions where necessary.
Prevent dirt and/or moisture getting into the device as it could possibly
falsify the measurements or cause damage.
Surfaces which come into contact with gas must be free of grease, oil, solvents and
other impurities.
To Next Page
Loading...
Need help?
General
