Honeywell ESSER Serial essernet Interface SEI1 - System Requirements for the FACP; SEI1 Variants

Serial essernet
®
interface (SEI1)
FB 798819 / 05.18 41
7.3 System requirements for the FACP
When connecting a serial essernet
®
interface to an ESSER fire alarm control panel, the following
FACP software versions are required:
Fire alarm control panel (FACP)
System software
from version
800x V2.41
IQ8Control V3.00
FlexES Control V04.01
7.4 SEI1 Variants
The following variants of the serial essernet

interface are available:
SEI1 variants Part No.
EDP
*1
unidirectional 784855
EDP
*1
bidirectional 784856
FACP 8000 / IQ8Control Remote 784859
EDP
*1
- Esser Data Protocol
The programming software SEI1 Setup version V1.06R002 and higher is required
if the standard configuration is to be changed. Further informations see Chapter 12.