Honeywell ESSER Serial essernet Interface SEI1 - Programming

Serial essernet
®
interface (SEI1)
FB 798819 / 05.18 63
12 Programming
The >SEI-Setup< programming software is required for programming the Serial essernet

interface type FACP 8000 / IQ8Control-Remote if the standard factory configuration needs to
be modified.
3
1
2
X12
Fig. 18: SEI1 Setup programming software

Serial essernet

interface

Panel interface (Part No. 769828)

Service PC with >SEI Setup< programming software
DIP switch setting
To transmit the individually edited customer data via the programming software >SEI-Setup<
the following DIP switch setting is required.
ON
1
2
S2/1 – programming mode  ON / programming active
ON
1
2
S2/1 – programming mode  OFF / programming not active
ON
1
2
S2/2 – load default settings  ON (factory setting)