Honeywell FMC2000 - Twa; Full Scale; Drift; Reset LEL

FMC2000 User’s Guide
15.9 TWA
(R) This gives a readout of the TWA value.
15.10 Full Scale
(R) N/A
15.11 Drift
(R) N/A
15.12 Reset LEL
(S) This only applies to a MeshGuard LEL. If the MeshGuard
LEL goes over range, you can reset the MeshGuard LEL to
normal.
1. Press Enter when you see the warning window.
2. When you see the confirmation window, press Enter.
WARNING!
Before you remotely reset the MeshGuard LEL, make sure that the
level of combustible gas(es) is actually below the alarm threshold
of the MeshGuard LEL.
52