Honeywell FMC2000 - Re-Obtain IP; Client MAC

FMC2000 User’s Guide
Check with your IT department for guidance on setting a Default
Gateway.
To set your Default Gateway:
1. Press Enter
2. Press a digit (1 through 9). After each number it advances to
next digit.
3. When the IP address has been input, press Enter.
18.2.8 Re-Obtain IP
This sets the IP address for the controller automatically through
DHCP (dynamic host configuration protocol).
Check with your IT department before re-obtaining an IP address
if your system is operating within a larger system.
To re-obtain the IP address:
1. Press Enter.
2. When you see “Confirm?” press Enter to confirm. Otherwise,
to leave unchanged, press Back.
18.2.9 Client MAC
A MAC (Media Access Control) address is an address used to
represent hardware devices on an Ethernet network. Each MAC
address is unique. An example of a MAC address is 00-13-20-80-
15-80.
Note: You cannot change the FMC2000’s Client MAC address.
69