FMC2000 User’s Guide
overhead to the system, it is recommended that you disable
TCP/IP if you are not using it.
There are only two options, Enable and Disable. Change the
setting in the following way:
1. Press Enter.
2. Press Up or Down to select Enable or Disable.
3. Press Enter.
18.2.2 Protocol Select
Two different protocols for Ethernet data transmission are
available. The options are RCS and Modbus.
To change the setting:
1. Press Enter.
2. Press Up or Down to select RCS or Modbus.
3. Press Enter.
66
To Next Page
Loading...
