Honeywell FMC2000 - Technical Support

FMC2000 User’s Guide
23 Troubleshooting
Problem
Possible Reasons & Solutions
Battery backup
cannot power the
FMC2000 after the
main AC power is
disconnected
Reasons: Battery hardware switch
is turned off.
Discharged battery.
Defective battery.
Solutions: Turn off the FMC2000,
and turn it on again using
its power switch.
Make sure main power is
connected and turned on.
Charge or replace
battery.
Lost password
Solutions: Call Technical Support
at +1 408-752-0723 or
toll-free at
+1 888-723-4800
Buzzer
Inoperative
Reasons: Bad buzzer.
Solutions: Check that buzzer is not
turned off.
Call authorized service
center.
FMC2000 cannot
receive and display
monitor(s)
Reasons: PAN IDs do not match.
FMC2000 is too far
from the monitor(s).
Solutions: Check PAN IDs.
Controller should be
closer to the monitor(s).
Press [Y/+] on the
MeshGuard.
81