FMC2000 User’s Guide
18.2 Ethernet Network
The FMC2000 can be connected to a network via Ethernet. This
requires using an Ethernet cable with an RJ-45 connector, plugged
into the port on the upper circuit board. The other end can be
plugged into a hub, router, or other access point to a network or to
the Internet. Communication is through the TCP/IP network
protocol.
To enter Ethernet settings:
1. Input the 6-digit advanced password.
2. Press Enter. The menu appears.
3. Step through the menu choices by using the up and down
arrows.
4. Select a menu choice by pressing Enter. Otherwise, press Back
to return to the Ethernet menu without making changes, or
press Exit to return to the monitoring screen.
The Ethernet menu includes:
• TCPIP Enable
• Protocol Select
• Server IP
• Server Port
• Client IP
• Subnet Mask
• Default Gateway
• Re-Obtain IP
• Client MAC
18.2.1 TCPIP Enable
In order for the TCP/IP connection to operate, it must be enabled
(by default, it is disabled). Because using TCP/IP increases
65
To Next Page
Loading...
