FMC2000 User’s Guide
If necessary, check with your IT department for guidance on
setting a Client IP address to be used within a network.
To set the Client IP address:
1. Press Enter
2. Press a digit (1 through 9). After each number it advances to
next digit.
3. When the IP address has been input, press Enter.
18.2.6 Subnet Mask
A subnet mask is used to identify a network within the larger
network. An example of a subnet mask is a number such as
255.255.255.0. Note that periods separate each of the four sets of
numbers.
Check with your IT department for guidance on setting a subnet
mask for your network.
To set the Subnet Mask:
1. Press Enter
2. Press a digit (1 through 9). After each number it advances to
next digit.
3. When the IP address has been input, press Enter.
18.2.7 Dflt Gateway
A default gateway is a node (a router) on a computer network that
serves as an access point to another network. Each Default
Gateway is defined by a number such as 172.18.12.81. Note the
periods between the four sets of numbers.
68
To Next Page
Loading...
