To the Installer
MPICLTEU (US), MPICLTEC (Canada)
For mobile and fixedoperating configurations, the antenna gain, including
cable loss, must not exceed 2.15 dBi at 700 MHz/850 MHz/1700 MHz/1900
MHz as defined in 2.1091 for satisfying RF exposure compliance. Under no
condition may an antenna gain be used that would exceed the 7W erp Part 22,
the erp 3W Part 27, the 2W eirp Part 24 and the 1W eirp Part 27 power limits.
4.5 Swapping the SIM Card
If you need to change the SIMcard in the LTE module, you must restart the
control panel. If not, the new SIM card will not work.
To swapthe SIMcard in the LTE module, proceed as follows:
1. Swap the SIM card.
2. Restart the panelusing the SHUTDOWN button. For details, see Shutting
Down the Panel Securely on page122.
3. Check the LTE module settings in MAXPRO Cloud, and test the
communication.
Caution!
If you change the Access Point Name (APN) for the LTEmodule in
MAXPRO Cloud (for example when changing providers), you have to
restart the control panel for the changes to take effect.
4.6 LED Indicators
LED Function
Power (green) Device is powered.
Network Connected
(yellow)
Network connection status:
l Short flash every 4seconds: idle, normal state.
l Short flash every 2seconds: data transfer in
progress.
l Fast flash (0.5s on, 0.5s off): no network or
connection issue.
56 800-23044 Rev. A draft_11
Installation and Setup Guide Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
To Next Page
Loading...
Need help?
General
