Caution!
For security reasons, change the default codes as soon as possible
from MAXPRO Cloud. For instructions, see the MAXPRO Cloud
Configuration Guide (doc. no. 800-24096).
5.3.9 Using the Keypad
This section describes the actions that only installers can perform on the
keypad. For the actions that are available to end users (customers), see the
MAXPRO Intrusion User Guide (doc. no. 800-23041).
5.3.9.1 Installer Access to the Keypad
You, as an installer, cannot log on to the keypaduntil the customer has
granted you access. If you need access to different keypads, the customer has
to grant you access on each keypad individually.
Note
After restarting the panel, the installer access on the keypad is
automatically blocked again.
Logging on to a keypad automatically disarms the keypad's home
area. Installers can only disarm areas if they armed the areas
themselves. So if the home area of the keypadis armed, then
installers can only log on to the keypadif they have armed that area
themselves. If someone else has armed the area, then the system
will deny installer access to the keypad.
To log on to the keypad:
l Using a PIN code:
1. Tap the screen to wake.
2. Tap again to display the pinpad.
3. Type your PIN code.
l Using a card: swipe the card along the bottom of the keypad.
If there is no activity on the keypad for 30seconds, the system will log out the
user automatically.
66 800-23044 Rev. A draft_11
Installation and Setup Guide Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
To Next Page
Loading...
Need help?
General
