Honeywell MAXPRO Intrusion MPIP2000U/3000U Series Installation and Setup Guide
800-23044 Rev.î A draft_11 69
5.4 MPI Door Control Module MPIDC1
5.4.1 About the MPI Door Control Module
The MAXPROIntrusion Door Control Module (DCM) is a single door access
control module and connects to an MPI Control Panel. It provides access and
egress to the protected premises. Adding more than one DCM increases the
number of access points and each communicates with an MPI Control Panel
via the IB2 communication bus. The module may be mounted remotely in its
own enclosure, or together with an MPI Remote Power Supply in a cabinet.
5.4.2 Features
Access control:
l Compatible with two Wiegandreaders
l One programmable 12îVDCrelay for door lock
l Selectable entry (access) vs. exit (egress) reader
1
l Outputs to control reader, reader buzzer, and up to three reader LEDs.
l Supports up to the last 500 cards in reduced capability mode.
Burglary:
l Door is usable as entry/exit door as part of the burglary protection, using
the door status monitor input. Only one magnetic contact required for
access and burglary functionality.
Tamper protection:
l Lid and off-wall tamper protection.
l Bypassable through MAXPRO Cloud.
l Tampers for both readers.
Card formats, Wiegand:
l HID cards: 26, 32, 34, 35, and 48 bit.
l Mifare cards: Classic 32-bit and Desfire 56-bit.
l EM4102 cards 26, 40 bit.
1
Exit reader will be available soon.
To Next Page
Loading...
Need help?
General
