Honeywell MAXPRO MPIP2000U Series - Mounting the Cabinet

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series Installation and Setup Guide
800-23044 Rev. A draft_11 29
# Purpose Dimensions
M Knockout for optional off-wall tamper switch (x1) 7/16in x 7/8in
N Screw hole for mounting MPI Remote Power Supply (x1above
and x1below mounting rails)
Diameter 3/16in

Caution!
If you are using cable glands or blanking plugs, make sure they
match the knockout/conduit size to provide accurate (cable)
protection. If using non-metal materials, make sure they comply with
UL94 V-0.
Detailed dimensions of the screw holes for cabinet mounting are indicated
below:
0.25 in
0.83 in
0.47 in
0.47 in
0.25 in
3.2.3 Mounting the Cabinet

Warning!
If mounting the cabinet higher than 2m above the ground, take the
necessary safety precautions to prevent personal injury.