Honeywell MAXPRO Intrusion MPIP2000U/3000U Series Installation and Setup Guide
800-23044 Rev. A draft_11 65
LED Colour Icon Function
arming.
Red Area armed: The keypad's home area is armed.
Green Power: Power is present.
Note
l The keypad will indicate a warning message when the connection
to the control panel is lost (“Keypadnot connected”).
l Icon indications are not visible if the LED is not lit.
l If an event occurs, the keypad's sleep screen (=screen that
displays if no user is logged on) will show the event details (zone
andarea name). If you want to hide the details, you can program
this behaviour using MAXPRO Cloud, for all keypads attached to
the control panel. To hide the event details on the sleep screen; go
to the control panel’s Settings screen, and disable the option
Show Alert Details on Arming Station Sleep Screen. (The
option is enabled by default.) If the site has multiple control
panels, check the setting for each control panel.
UL
For CAN/ULC-S304 compliance, install the keypad so that the system
status (armed/disarmed, status LED) is not visible from outside the
protected premise.
5.3.8 Keypad Default Users and Authority Levels
The system is shipped with the following defaults for the user codes:
User 6-digit code 5-digit code 4-digit code
Installer 111222 11122 1112
Master 654321 65432 6543
The default PINlength is 4digits.
These default codes allow the installer to get the system physically installed
andto run initial testing without the need to connect to MAXPROCloud.
To Next Page
Loading...
Need help?
General
