Honeywell MAXPRO MPIP2000U Series User Manual

l Mifare (Classic 32-bit andDesfire 56-bit) cardtype support.
l Lid and off-wall tamper protection.
5.3.3 Operational Commands
l User authorization
l Arm/disarm (set/unset), andreset
l View faults, troubles, and alarms
l Bypass zones
l Emergency buttons (panic, medical, and fire emergency; configurable per
area)
l View and operate other areas
l View activity log
l View zone status
l Run zone walk test, siren test.

Note
Besides using the keypad, the customer can arm/disarm the system
using the mobile app, via Visual Management in MAXPRO Cloud, or
automatically using Schedules in MAXPROCloud.
5.3.4 Mounting and Wiring
UL
For CAN/ULC-S304 compliance, install the keypad so that the system
status (armed/disarmed, status LED) is not visible from outside the
protected premise.

Note
For details on using the optional keypad wall mounting plate, see
Using the Optional Wall Mounting Plate on page63.
To mount and wire the keypad, proceed as follows:
1. Find a flat, verticalsurface in a convenient location.
60 800-23044 Rev. A draft_11
Installation and Setup Guide Honeywell MAXPRO Intrusion MPIP2000U/3000U Series

Honeywell MAXPRO MPIP2000U Series Specifications

General

Brand	Honeywell
Model	MAXPRO MPIP2000U Series
Category	Security System
Language	English