Honeywell MCT404 - Figure 3-7 Block Recognizer

3. Getting Started
3.9. Types of input methods
24 MC Toolkit (MCT404) User Manual Revision 3
Character input using Block Recognizer
For character input using block recognizer, perform the following steps.
1. Tap on the arrow at the bottom right corner of the display and tap on Block Recognizer.
2. Use the stylus to provide a character input to the letter pad at the bottom of the screen. The
character strokes are then converted to typed text on the screen as shown below in Figure 3-7.
Figure 3-7 Block Recognizer
Note: Tap on ? icon to view the help for using Block Recognizer, and tap on @$ icon to view the table
of symbols.