Honeywell MCT404 - Table 13 de Main Menu Procedures

5. Managing DE Devices using MC Toolkit Software
5.5. Online configuration
Revision 3 MC Toolkit (MCT404) User Manual 77
Table 13 DE Main Menu Procedures
DE Main Menu Procedures
DE Main Menu
(ST 3000)
ST 800
(STT 3000)
ST850/STT750 Local
Display Support
Note:
This message appears if
the <Back button is
selected if the
transmitter was set to
Output Mode (in
Calibration procedures),
and the Output was not
later cleared.
Various buttons are
provided on the Main
Menu to navigate to
different screens.
Save to File allows saving
the current device
configuration to a file.
More detail on this under
“Save To File in Online
Mode” Procedure
Device Info
Type field will show
“ST 800” when ST 800
device is connected
Tag ID (r/w)
User ID up to 8
alphanumeric characters
(suggestion: relate to
functional process entities
and/or plant areas).
Type (r)
Manufacturer's device
type identifier (typically, a
model number)
Firmware Version
(r)Manufacturer's
Firmware version identifier
Serial Number (r)
Manufacturer
Scratch Pad (r/w)
Up to 32 alphanumeric
characters (suggestion:
messages to control room
regarding
observed/assigned
operational status)