www.honeywell.com/security
20 |
MPA1 User Guide
Figure 2-2 Selecting Host/Loop Communication Tab
3. Set up Communication attributes (see Figure 2-2):
a. Select Web as Host Connection Type.
b. Ethernet Virtual Loop is the only available option.
c. Click Save.
4. See Setting Up an Ethernet Port on page 6.
5. Set up Network Configuration (see Figure 2-3):
a. Navigate to the Network field on the Settings tab.
b. Select DHCP or enter Static IP address assigned to Primary panel.
c. Click Save. The panel automatically reboots.
Note It is recommended to set the Primary panel as a static IP address that is
different than the default address (192.168.1.150) such as 192.168.1.100.
The Primary panel must be set to the same subnet as the Secondary panels
in order for the EVL to work properly (i.e., if DHCP server is assigning
Secondary panels to 129.17.27.XXX, then Primary needs to also be set to
129.17.27.XXX).
To Next Page
Loading...
