AM-1224 Installation and programming manual PAGINA - 1
AM-1224_manu Doc. M-124.1-AM1224-ENG Rev A.1 NOTIFIER ITALIA
NOTE: Do not try to install the control unit and devices connected without reading this manual.
DETECTION SYSTEM LIMITS
An alarm or fire detection system can be very useful for the prompt warning of any dangerous event, such as fire, a robbery
or a simple burglary, in some cases it can automatically manage events (transmission of messages for room evacuation,
automatic fire-extinguishing, TVCC system interface, access route or door blockage, automatic warning to authorities, etc.),
but in any case, it does not ensure protection against damages to propriety or damages caused by fires or robberies).
Moreover, each system may not properly operate if it is not installed and maintained according to the manufacturer’s
instructions.
PRECAUTIONS
These instructions contain procedures to be followed in order to avoid damages to
equipment. It is assumed that the user of this manual has performed a training course and
that he knows the applicable rules in force.
The system and all its components must be installed in an environment having the following
features:
Temperature: -5 °C ¸ +40 °C.
Humidity: 10 % - 93 % (without condensation).
Peripheral devices (sensors, etc.) which are not perfectly compatible with the control unit
may cause damages to the same control unit, and a bad operation of the system in any
moment. Therefore, it is essential to only use material which is guaranteed by NOTIFIER
and is compatible with its own control units.
Please consult NOTIFIER Technical Service for any doubt.
This system, like all solid state components, may be damaged by induced electrostatic
voltages: handles the boards keeping them among the edges and avoid to touch the
electronic components.
An appropriate earthing connection ensures, in any case, a sensitivity reduction to
disturbances.
Please consult NOTIFIER Technical Service if you cannot solve installation problems.
Any electronic system does not operate if it is not powered.
If power supply from the mains fails, the system ensures its operation through battery, but
only for a limited period of time.
During the system planning phase, take into account the autonomy required to appropriately
dimension the power supply and batteries.
Skilled personnel shall periodically check the state of batteries.
Disconnect the MAINS and the batteries BEFORE removing or inserting any board.
Disconnect ALL power supply sources from the control unit, BEFORE performing any
servicing.
The control unit and the connected devices (sensors, modules, annunciators, etc.) may be
damaged, if a new board is inserted or removed, or if the powered cables are connected.
The most common cause for malfunctioning is inappropriate maintenance.
Take special care of these aspects since you start the system planning phase; this will
facilitate future servicing and will reduce cost.
This device is marked CE to certify it is in conformity with the requirements of the European
community Directives:
Electromagnetic Compatibility Directive 89/336/EEC (and the directive 92/23/EEC)
Low Voltage Directive 73/23/EEC
NATIONAL RULES
This device must be installed and must operate in accordance with these instructions
and to the rules in force in the installation place.
To Next Page
Loading...
