To Next Page

To Previous Page

48 FireWarden 100-2/E — P/N 52778:A 11/04/2005

Programming Master Programming Level

The following examples show the editing of a photoelectric smoke detector with address 017,

located on the SLC loop:

Enable/Disable Detector

To Enable or Disable the detector, press the 1 key while viewing the Edit Detector Screen #2. Each

press of the key will toggle the screen between Enabled Yes and Enabled No. If Enabled No is

selected, the detector will not be polled by the control panel, preventing the detector from reporting

alarms and troubles to the panel. The control panel will display the device type and address which

has been disabled and will turn on the Trouble LED and Disable LED.

EDIT DETECTOR 1D017

1=ENABLED YES

2=TYPE SMOKE(PHOTO)

3=VERIFICATION OFF

Edit Detector Screen #2

EDIT DETECTOR 1D017

1=WALKTEST NO

2=PAS NO

3=PRE-SIGNAL NO

Edit Detector Screen #3

EDIT DETECTOR 1D017

1=ZONE ASSIGNMENT

00 ** ** ** **

Edit Detector Screen #4

Edit Detector Screen #5

EDIT DETECTOR 1D017

1=NOUN/ADJECTIVE

2=DESCRIPTION

********************

EDIT DETECTOR

1=ENABLED

2=TYPE

3=VERIFICATION

Edit Detector Screen #2

Honeywell NOTIFIER FireWarden-100-2 User Manual

Questions and Answers: