96 FireWarden 100-2/E â P/N 52778:A 11/04/2005
Programming Master Programming Level
î
Service Terminal
The NFW2-100 can be programmed remotely from a PC using a modem and telephone line.
Information can also be retrieved from the FACP using the same method. The Upload/Download
option allows an operator to set the necessary parameters to allow the uploading and downloading
of data between the FACP and PC. The Service Terminal selection provides the means for entering
these parameters.
Pressing 1 while viewing On Board DACT Screen #2 will cause the following screens to appear:
Panel ID
The Panel Identification Number is a 4-digit code (valid digits being 0 - 9 and A - F) that is used to
identify the installed FACP. It is important to program this code into the FACP the first time that
downloading is performed so that the called Service Terminal can identify the control panel. The
factory default is 0000.
To program the Panel ID, press 1 while viewing Service Terminal Screen #1. The following screen
will be displayed:
A flashing cursor will appear in the lower left corner of the display. Enter a 4-digit code using the
digits 0 - 9 and/or the letters A - F by entering the first character. Press the right arrow key to move
the cursor to the second position and enter the second character. Follow the same procedure to
enter the remaining characters. After entering the fourth character, press the right arrow key and
then press the Enter key to store the Panel ID number.
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE
On Board DACT Screen #2
SERVICE TERMINAL
1=PANEL ID 0000
2=TERMINAL 1
3=TERMINAL 2
Service Terminal Screen #1
SERVICE TERMINAL
1=RING COUNT 3
Service Terminal Screen #2
PANEL ID
4 CHARACTER 0-F
Panel ID Screen
To Next Page
Loading...
Need help?
General
