Name: Honeywell NOTIFIER SLC
Brand: Honeywell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

52 Notifier SLC Wiring Manual — P/N 51253:U9 12/3/2021

Multiple Input/Output Modules NFPA Class B IDC Wiring Using Dual Monitor Modules

Refer to the Device Compatibility Document for compatible smoke detectors.

Heat

Detector

Manual

Pull

Station

SLC

FDM-1

Base +1 Address

(IDC Circuit H)

Base Address

(IDC Circuit L)

47K

ELR

47K

ELR

Figure 9.3 Typical Class B IDC Wiring with FDM-1

Table of Contents5
Section 1: Introduction8
About this Manual8
UL 864 Compliance8
1: Products Subject to AHJ Approval8
Reference Documentation9
SLC Overview12
Polling Protocols13
1: Available Protocols13
2: Protocol Use13
Devices13
1: Monitor/Zone Interface Module13
2: Control Modules13
3: Isolator Modules14
4: Relay Modules14
5: Multiple Input/Output Modules14
6: Transponders14
7: Plug-In Detector Bases14
8: Intelligent Detectors15
9: Addressable Manual Pull Stations16
10: Wireless Interface16
11: ACPS-610 Addressable Charger/Power Supply16
12: ACPS-2406 Addressable Charger/Power Supply17
13: AMPS-24 Addressable Power Supply17
14: PMB-AUX Addressable Charger/Power Supply17
SLC Capacity17
SLC Performance17
LED Operation17
Section 2: Wiring Requirements19
Recommended SLC Wiring19
Two-Wire SLC - Class B21
1: Measuring Loop Resistance21
2: Measuring Total Wire Length21
Four-Wire SLC Class a and X22
1: Measuring Loop Resistance22
2: Measuring Total Wire Length22
Control Panel Terminal Blocks23
1: N16 with SLM-318 Signaling Loop Module23
2: NFS2-3030 and NFS-3030 with LCM-320, LEM-32023
3: NFS2-640 with Loop Expander Modules, NFS-320 and NFS-320SYS24
4: NFS-640 with Loop Expander Modules24
5: Afp-10024
6: Afp-20024
7: Afp-300/Afp-40025
8: AM2020/AFP1010 with LIB-200A or LIB-40025
9: System 5000 with AIM-20025
Section 3: Shielded Wire Termination26
Overview26
No Conduit26
Full Conduit26
Partial Conduit27
Floating Shield27
Section 4: SLC Circuits Without Isolators28
Overview28
NFPA Class B SLC28
NFPA Class a SLC29
Section 5: SLC Circuits with Isolators30
Overview30
Fault Isolator Modules30
Isolator Detector Bases31
1: How an Isolator Base Works31
NFPA Class B SLC Using Isolator Modules33
NFPA Class a SLC Using Isolator Modules35
NFPA Class X SLC Using an Isolating Device36
Section 6: Monitor Modules37
Description37
1: Addressable Monitor Module37
2: Zone Interface Module37
3: Miniature Monitor Module38
4: FMM-4-20 4-20Ma Monitor Module38
Setting an SLC Address for a Module38
NFPA Class B IDC Using Monitor Modules39
NFPA Class a IDC Using Monitor Modules40
NFPA Class B IDC Using Zone Interface Modules41
NFPA Class a IDC Using Zone Interface Modules42
Section 7: Control Modules44
Description44
1: Setting an SLC Address44
Wiring a NAC with Addressable Control Modules44
1: Wiring a Solenoid with the FCM-1-REL45
Wiring a Class B NAC (Two-Wire) with Addressable Control Modules45
Wiring a Class a NAC (Four-Wire) with Addressable Control Modules46
Connecting a Releasing Device to the Addressable Control Module47
Section 8: Relay Module49
Description49
1: Setting an SLC Address49
Wiring the Addressable Relay Module (Form-C Relay)49
Section 9: Multiple Input/Output Modules50
Description50
1: Fdm-150
2: Fdrm-150
Setting the SLC Address50
Wiring the Dual Monitor Module50
Wiring the Addressable Dual Monitor/Dual Relay Module51
NFPA Class B IDC Wiring Using Dual Monitor Modules51
Section 10: Intelligent Detectors, Intelligent Detector Bases, and Wireless Gateway53
Description53
1: Intelligent Detector Bases53
2: Intelligent Aspiration Detectors53
3: Wireless Gateway54
Wiring a Detector Base54
Wiring an Isolator Base56
Wiring a Relay Base56
Wiring a Sounder Base57
Wiring and Programming Aspiration Detectors58
Wiring the FWSG(A)62
1: SLC Connections62
Power Connections: Powered by the SLC63
1: Power Connections: External, Regulated +24 VDC Power Source64
Section 11: Addressable Manual Pull Stations65
Description65
1: Setting an SLC Address65
Wiring a Manual Pull Station65
Appendix A: Power Considerations66
A.1: Supplying Power to 24 VDC Detectors and Nacs66
A.2: Supervising 24 VDC Power66
A.2.1: Using Type Codes with Built-In Power Supervision on N16, NFS2-3030, NFS-3030, NFS2-640, NFS-320 and NFS-320SYS66
A.2.2: Power Supervision Relay66
A.2.3: Using the Addressable Control Module Without Relay68
A.3: Basics of Class a Power Supervision70
Appendix B: SLC Surge Suppression71
B.1: Introduction71
B.2: Installation71
Appendix C: Terminal Conversion Charts for V-Type and H-Type Devices72
C.1: Frm-172
C.2: FCM-1 and FZM-172
C.3: Fmm-173
C.4: Ftm-173
C.5: Fdm-174
Appendix D: Intelligent Detector Base Layouts for Legacy Devices75
D.1: Wiring a Detector Base75
D.2: Wiring an Isolator Base76
D.3: Wiring a Relay Base76
D.4: Wiring a Sounder Base77
Appendix E: Canadian Versions of SLC Devices78
Index85

Honeywell NOTIFIER SLC User Manual

Table of Contents

Questions and Answers:

Honeywell NOTIFIER SLC Specifications

Related product manuals

Brand	Honeywell
Model	NOTIFIER SLC
Category	Control Panel
Language	English