102 6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
8.2.4 Mapping LED Points
Figure 8.6 is a simple example showing how LED points are mapped to zones and output groups. Typically you would create two output
groups for each zone, one for alarms and one for troubles. (LED points are available when Models 5865-3/4 and/or 5880 are used with
the system.)
Figure 8.6 Example of LED Points Mapped to Output Groups
(Applies to Models 5865-3/4 and 5880)
8.3 Programming Using the HFSS Software Suite
You can use the HFSS Honeywell Fire Software Suite to program the control panel onsite (personnel will need to be onsite during the
upload or download process). HFSS is a software package that lets you easily program the control panel using a Windows-based com-
puter. HFSS is needed for Mapping. When using HFSS, you can set up the programming options for the panel, save the options in a file,
then download the file to the panel. You can connect to the control panel directly using the onboard USB or Ethernet. Updates are avail-
able at www.silentknight.com.
8.4 Programming Using an Annunciator
You can program the control panel from a system annunciator, using either the control panel’s on-board annunciator or a 5860, 6860 &
6855 remote annunciator.
The following subsections describe programming basics, including a description of editing keys available for programming and how to
move through programming menus. Section 9 contains specific information about individual programming options.
NOTE: Mapping cannot be programmed through the on-board and remote annunciators. Mapping is only available through HFSS Honeywell
Fire Software Suite up/downloading software.
To Next Page
Loading...
